An administrator needs to create a partial PRI consisting of the first seven timeslots available. Which
configuration snippet configures the ISDN E1 PRI for this task?
A customer reports that the Cisco UCM toll-fraud prevention does not work correctly, and the
customer is receiving charges for unapproved international calls as a result. Which two configuration
changes resolve the issues? (Choose two.)
config t
2900(config)#isdn switch-type primary-ni
2900(config)#interface Serial0/0/0:15
2900(config-controller)#pri-group timeslots 1-7
config t
2900(config)#isdn switch-type primary-ni
2900(config)#controller e1 0/0/0
2900(config-controller)#pri-timeslots 1-7
config t
2900(config)#isdn switch-type primary-ni
2900(config)#controller e1 0/0/0
2900(config-controller)#pri-group timeslots 1-7
config t
2900(config)#isdn switch-type primary-ni
2900(config)#pri-group timeslots 1-7
A.
Mark patterns as off-net or on-net.
B.
Modify the Block OffNet to OffNet Transfer service parameter.
C.
Disable call forwarding on the phone.
D.
Use Cisco Unified Border Element to debug the calls.
E.
Make the calls route through a firewall.
Correct Answer: C
Explanation not available for this question.
Question #2 (Topic: demo questions)
When a call Is delivered to a gateway, the calling and called party number must be adapted to the
PSTN service requirements of the trunk group. If a call is destined locally, the + sign and the explicit
country code must be replaced with a national prefix. For the same city or region, the local area code
must be replaced by a local prefix as applicable. Assuming that a Cisco UCM has a SIP trunk to a New
York gateway (area code 917). which two combinations of solutions localize the calling and called
party for a New York phone user? (Choose two)
A.
Configure two calling party transformation patterns: \+1917.XXXXXXXX, strip pre-dot, numbering type: subscriber\+1917.!, strip pre-dot, numbering type: national
B.
Configure the gateway to translate called numbers and apply it to the dial peer. Combine it with a translation profile for calling numbers. Plaintext
Configure two called party transformation patterns: \+1917.XXXXXXXX, strip pre-dot, numbering type: subscriber\+1917.!, strip pre-dot, numbering type: national
Correct Answer: B, C
Explanation not available for this question.
Question #3 (Topic: demo questions)
Refer to the exhibit. An engineer configures a VoIP dial peer on a Cisco gateway. Which codec is
used?